Nitrosys Refill
NitrosysRefill is a simple and flexible line of spray foam equipment ideal for those looking to start off in the spray foam business and for existing insulation contractors looking to improve production and reduce cost
Lower Power Requirement, Reduced Noise
The low pressure spray foam in the Nitrosys Refillable Spray Foam System is packaged in pressure vessels that are shipped to the user. Upon completion of the spray foam application, the manufacturer will arrange for the pressure tanks to be shipped back to the facility for refilling. The Nitrosys Low Pressure, Refillable Spray Foam System saves time, lowers material and transportation costs and eliminates drum disposal. Because of the low pressure static mix that occurs during the application of LP spray foam, atomization does not occur and VOC’s do not saturate the air; like they do during the application of high pressure spray foam. This allows occupants to re-enter the structure only one hour after the spray application has occurred. Also due to the low pressure static mix and no atomization, installers can wear PPE (personal protective equipment) that consists of organic vapor acid gas respirator cartridges. No fresh air pump is required like during the application of HP spray foam.
Refillable Tanks, Less Exposure to Raw Chemical
No more extremely loud, diesel, spray foam generators when working with the Nitrosys Spray Foam System. Less power is required to run the spray foam system, allowing the applicator to use a much smaller generator or shore power, and reduce the noise produced. The system utilizes nitrogen tanks to pressurize material cylinders and push material into the proportioner, while also operating the proportioner. Low pressure spray foam application will allow for a reduction of up to 80% in over spray during the application process compared to high pressure spray foam applications. The process temperature is also lower than hp spray foam which makes applying lp spray foam in colder climates. The Nitrosys spray foam system’s preheating, and auto-calibration unit can easily be added to an existing mobile spray foam rig. The spray foam system requires less spray foam equipment to be used and it’s small, compact size allows the unit to be put into smaller vehicles such as a sprinter van.